diff --git a/drivers/gpu/drm/nouveau/nouveau_drm.c b/drivers/gpu/drm/nouveau/nouveau_drm.c
index 6b1629c14dd7e99d6713bc969378d6c813a3362a..ca4087f5a15b6c043ddc5245c722dc32049fda3c 100644
--- a/drivers/gpu/drm/nouveau/nouveau_drm.c
+++ b/drivers/gpu/drm/nouveau/nouveau_drm.c
@@ -618,6 +618,64 @@ nouveau_drm_device_fini(struct drm_device *dev)
 	kfree(drm);
 }
 
+/*
+ * On some Intel PCIe bridge controllers doing a
+ * D0 -> D3hot -> D3cold -> D0 sequence causes Nvidia GPUs to not reappear.
+ * Skipping the intermediate D3hot step seems to make it work again. This is
+ * probably caused by not meeting the expectation the involved AML code has
+ * when the GPU is put into D3hot state before invoking it.
+ *
+ * This leads to various manifestations of this issue:
+ *  - AML code execution to power on the GPU hits an infinite loop (as the
+ *    code waits on device memory to change).
+ *  - kernel crashes, as all PCI reads return -1, which most code isn't able
+ *    to handle well enough.
+ *
+ * In all cases dmesg will contain at least one line like this:
+ * 'nouveau 0000:01:00.0: Refused to change power state, currently in D3'
+ * followed by a lot of nouveau timeouts.
+ *
+ * In the \_SB.PCI0.PEG0.PG00._OFF code deeper down writes bit 0x80 to the not
+ * documented PCI config space register 0x248 of the Intel PCIe bridge
+ * controller (0x1901) in order to change the state of the PCIe link between
+ * the PCIe port and the GPU. There are alternative code paths using other
+ * registers, which seem to work fine (executed pre Windows 8):
+ *  - 0xbc bit 0x20 (publicly available documentation claims 'reserved')
+ *  - 0xb0 bit 0x10 (link disable)
+ * Changing the conditions inside the firmware by poking into the relevant
+ * addresses does resolve the issue, but it seemed to be ACPI private memory
+ * and not any device accessible memory at all, so there is no portable way of
+ * changing the conditions.
+ * On a XPS 9560 that means bits [0,3] on \CPEX need to be cleared.
+ *
+ * The only systems where this behavior can be seen are hybrid graphics laptops
+ * with a secondary Nvidia Maxwell, Pascal or Turing GPU. It's unclear whether
+ * this issue only occurs in combination with listed Intel PCIe bridge
+ * controllers and the mentioned GPUs or other devices as well.
+ *
+ * documentation on the PCIe bridge controller can be found in the
+ * "7th Generation Intel® Processor Families for H Platforms Datasheet Volume 2"
+ * Section "12 PCI Express* Controller (x16) Registers"
+ */
+
+static void quirk_broken_nv_runpm(struct pci_dev *pdev)
+{
+	struct drm_device *dev = pci_get_drvdata(pdev);
+	struct nouveau_drm *drm = nouveau_drm(dev);
+	struct pci_dev *bridge = pci_upstream_bridge(pdev);
+
+	if (!bridge || bridge->vendor != PCI_VENDOR_ID_INTEL)
+		return;
+
+	switch (bridge->device) {
+	case 0x1901:
+		drm->old_pm_cap = pdev->pm_cap;
+		pdev->pm_cap = 0;
+		NV_INFO(drm, "Disabling PCI power management to avoid bug\n");
+		break;
+	}
+}
+
 static int nouveau_drm_probe(struct pci_dev *pdev,
 			     const struct pci_device_id *pent)
 {
@@ -699,6 +757,7 @@ static int nouveau_drm_probe(struct pci_dev *pdev,
 	if (ret)
 		goto fail_drm_dev_init;
 
+	quirk_broken_nv_runpm(pdev);
 	return 0;
 
 fail_drm_dev_init:
@@ -734,7 +793,11 @@ static void
 nouveau_drm_remove(struct pci_dev *pdev)
 {
 	struct drm_device *dev = pci_get_drvdata(pdev);
+	struct nouveau_drm *drm = nouveau_drm(dev);
 
+	/* revert our workaround */
+	if (drm->old_pm_cap)
+		pdev->pm_cap = drm->old_pm_cap;
 	nouveau_drm_device_remove(dev);
 	pci_disable_device(pdev);
 }
diff --git a/drivers/gpu/drm/nouveau/nouveau_drv.h b/drivers/gpu/drm/nouveau/nouveau_drv.h
index c2c332fbde9793c6c93be0b53b920c1359d9bf0f..2a6519737800ca0154d06d0928f0e92635c9e49a 100644
--- a/drivers/gpu/drm/nouveau/nouveau_drv.h
+++ b/drivers/gpu/drm/nouveau/nouveau_drv.h
@@ -140,6 +140,8 @@ struct nouveau_drm {
 
 	struct list_head clients;
 
+	u8 old_pm_cap;
+
 	struct {
 		struct agp_bridge_data *bridge;
 		u32 base;